Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Using SD reader seperately

Created by: Joe K. at: 1/15/2010 5:21 PM (2 Replies)

Rating (1)

Thanks 1

3 Entries

1/15/2010 5:21 PM	Rate (0)
Joe K. Posts: 1 Rating: (0)	Hi, I'll apologize in advance for my ignorance. I have been working with the s7-300 for only a few days (my first experience with plc's at all.) I am trying to figure out if I am able to load information directly into anmmc from a pc via anmmc reader and then insert it into the s7-300 cpu. Basically I would like to develope from my desk at work and then bring it out to the plc. Any help would be greatly appreciated. Thank you!
Joe K. Posts: 1 Rating: (0)	Last edited by: Joe K. at: 1/15/2010 6:16 PM
Suggestion To thank Quote Answer

1/15/2010 7:29 PM	Rate (1)
IBN-Service Posts: 8946 Rating: (999)	Joe K. Hi, I'll apologize in advance for my ignorance. I have been working with the s7-300 for only a few days (my first experience with plc's at all.) I am trying to figure out if I am able to load information directly into anmmc from a pc via anmmc reader and then insert it into the s7-300 cpu. Basically I would like to develope from my desk at work and then bring it out to the plc. Any help would be greatly appreciated. Thank you! Not possible! You need a special SIMATIC card reader or a PG. If you try to write a S7 - MMC with a windows - card reader, the MMC will be damaged and not usable for S7 anymore.
IBN-Service Posts: 8946 Rating: (999)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Joe K.

1/17/2010 8:43 PM	Rate (0)
tomearp Posts: 51 Rating: (3)	if you want to develop off-site you can use PLC SIM in step 7 to simulate inputs on a virtual CPU the manual for PLC SIM is here, should help you get started :)
tomearp Posts: 51 Rating: (3)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on