V90 F 1015

Hello everyone,

After disconnecting the servo motor from the drive, an F1015: Internal software error appeared on the drive.The motor was disconnected from the drive while the drive was powered. I tried to connect a new drive but I get the same error. In the user guide for this error it says to check:

Carry out a POWER ON (power off/on) for all components. (Tried, no success)

Upgrade firmware to the latest version (No tried).

Contact the Hotline.

Has anyone had a similar problem?

Is it possible that the problem is in the servo motor?

Hello,

try to do firmware update, most of problems with V90 firmware are solved by upgrade.

With regards

Martin