Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

View speed and acceleration curve of online cam

Created by: DavidBrown at: 3/7/2021 5:35 PM (2 Replies)

Rating (1)

Thanks 1

3 Entries

3/7/2021 5:35 PM	Rate (0)
DavidBrown Gold Member Joined: 6/29/2012 Last visit: 12/25/2023 Posts: 975 Rating: (9)	I create cams in runtime in S7 1500T v16 with the LCamHdl Library. If I want to see the position profile of the generated profile I can do that in the cam editor by uploading the online values. But I am also interessted in the curves of speed and acceleration and jerk. However I do not acquire them by uploading. Is there a way however to see these curves for cams generated with LCamHdl library? In Simotion this was possible indirectly by uploading the cam in camedit,and then converting the cam to camtool.

Suggestion To thank Quote Answer

3/8/2021 3:11 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 1/22/2025 Posts: 5985 Rating: (825)	Hello, LCamHdl library has an HMI appliction, too. Create and show in HMI. https://support.industry.siemens.com/cs/ww/en/view/105644659 This application uses MC_GetCamFollowing value, to show speed and acceleration.
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

3/9/2021 8:32 AM	Rate (1)
bb2126 Regular Member Joined: 12/16/2014 Last visit: 10/23/2024 Posts: 11 Rating: (2)	Hi, have you tried to add and enable new curves like "Online speed", "Online acceleration" and "Online jerk". You can access this settings via "Properties" - "Charts" - "Charts and curves"

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users AutoGen_6695830

|

Share this page:

Share this page on...

Follow us on