Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

VM adress value in LOGO OBA7

Created by: LOGO678 at: 10/6/2015 11:12 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/6/2015 11:12 AM	Rate (0)
LOGO678 Posts: 4 Rating: (0)	Hello, I have a LOGO OBA7 working in a existing project. I am worried about 2 VM adresses V0.0 and V3.1. If I use the Data Table in Diagram mode (online), I see for both adresses the same value: 2#0, unless V0.0 is "0" and V3.1 is "1". I like to force V3.1 to "0" by netering a new value. Why are the values equal? And witch value do I enter to set V3.1 to "0". Regards
LOGO678 Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

10/6/2015 11:19 AM	Rate (0)
ixo65 Grandmaster-Expert Joined: 12/18/2014 Last visit: 12/3/2023 Posts: 31538 Rating: (3919)	Who write into the two addresses? Have you a HMI or a second logo or something else in the project?

Suggestion To thank Quote Answer

10/6/2015 11:44 AM	Rate (0)
LOGO678 Posts: 4 Rating: (0)	Problem solved! Unfortunately I was looking in the wrong Data Table.... Thanks anyway!
LOGO678 Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on