Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Warning, sum of resources exceed the maximum, but there is only one

Created by: Goran_ at: 1/15/2017 2:57 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

1/15/2017 2:57 AM	Rate (0)
Goran_ Posts: 141 Rating: (0)	Hi, "Warning triangle in the column Dynamic When a warning triangle are showed in the column “Connection resources” / “Dynamic” it is means that the sum of each individual resources (for CPU, CP and CM) exceed the maximum for the station, and because this, it will be reduced/limited." I have an example when I am using only one resource, but the exclamation mark is still shown. Here is an example where I simulate S7 communication between 2 PLC using S7-PLCSIM v13 (see attached image). Why am I receiving warning triangle? ------------------------------------------------------------------------------------------ Split from TIP: S7-1500 connections resources. Attachment Dynamic.png (358 Downloads)
Goran_ Posts: 141 Rating: (0)	Last edited by: Min_Moderator at: 1/16/2017 1:44:41 PM New subject after splitting
Suggestion To thank Quote Answer

1/23/2017 4:21 PM	Rate (0)
david_bautista Regular Member Joined: 8/11/2016 Last visit: 11/24/2023 Posts: 4 Rating: (0)	I experienced the same, is it caused by PLC sim?

Suggestion To thank Quote Answer

3/26/2019 8:13 PM	Rate (0)
mrkvak Member Joined: 2/4/2014 Last visit: 12/1/2023 Posts: 2 Rating: (0)	The mean of warning is that sum of all module resources is higher that station resources. So to use all available resources of all modules you need bigger PLC. Only warning, should not cause issues.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on