Warnings

Good morning forum,

Im trying to activate a warning using I0.2 (when its closed it displays the warning) i configured it perfectly using internal buttons on the hmi (TP700) but when i went to connect it to a 1200 i could only get the warning to pop up but with no text.

After going into the configuration of the warnings i realized that the warning that i wanted to activate was in red as seen in the image, how do i get the text joined up to the pop up window using an external cpu (simatic s7-1200)

Hi!

Looks like you use the same trigger bit (bit 0) of your trigger tag for two different discrete alarms.

Check this out:

https://support.industry.siemens.com/cs/document/62121503/configuration-of-messages-and-alarms-in-wincc-(tia-portal)?dti=0&lc=en-WW