Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

wear offset get erased when machine switch off & ON

Created by: ŠΜS at: 5/10/2012 5:52 PM (3 Replies)

Rating (2)

Thanks 1

4 Entries

5/10/2012 5:52 PM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 7/9/2024 Posts: 571 Rating: (37)	Hello, i have faced any typical problem in 840D controller lathe, In that when we switch off and ON the power, the value entered in the Wear offset get Earsed.I have checked in DOCON , related parameter, but i could not find. Did any one faced this type of problem??
	Regards, ŠΜS
Suggestion To thank Quote Answer

5/10/2012 6:38 PM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	ŠΜS Hello, i have faced any typical problem in 840D controller lathe, In that when we switch off and ON the power, the value entered in the Wear offset get Earsed.I have checked in DOCON , related parameter, but i could not find. Did any one faced this type of problem?? Hello.... I faced the problem in base offset....but there is channel machine for correcting this. Provide me the NCU -HMI version details.... Regards, Prakash
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Vithani

5/11/2012 2:59 PM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 7/9/2024 Posts: 571 Rating: (37)	Hi, NCK Version is 12.06.00 & MMC 04.03.17
	Regards, ŠΜS
Suggestion To thank Quote Answer

5/12/2012 9:51 AM	Rate (2)
Ekalavya Posts: 2964 Rating: (484)	Hello... Provide me the HMI version i will try to simulate it and check Provide me the NC backup...take the backup i.e upload MD changes---11210->00 Regards, Prakash
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on