Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

why CPU always in stop mode

Created by: simatix at: 10/8/2008 6:24 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

10/8/2008 6:24 AM	Rate (0)
simatix Experienced Member Joined: 7/8/2008 Last visit: 5/31/2023 Posts: 51 Rating: (0)	dear all members, Does anybody know why the 928 CPU always in stop mode and cannot be overall reseted? i have a system to be tested, with spesification below: Cpu = 6ES5 928 - 3UA12 without memory modules attached rack = 6ES5 188 - 3UA32 Psu = 6ES5 955- 3LC41 I/o = 6ES5 430-4UA13 The problem is CPU always in stop mode, unable to be overall reset. STOP ledflashing continously, BASP led lit. from the manual, I followed a clue to check the istack. Below are the result: STP, URL-IA, MOD-FE, UA-SYS and sometimes DB2-FE i also have been check the RS 3 and Rs4 (EA03 and EA04) address, Both of them give 0000 as the results. Could you tell me whats wrong? and would you mind to share the solution? Thank you, Simatixplc@yahoo.com

Suggestion To thank Quote Answer

10/8/2008 7:37 AM	Rate (0)
playerslight Posts: 1064 Rating: (72)	Could you do a screen shot of the i stack and b stack , this would help to diagnosis your problem
playerslight Posts: 1064 Rating: (72)
Suggestion To thank Quote Answer

10/8/2008 8:13 AM	Rate (0)
UMENCHO Diamond Expert Joined: 3/21/2006 Last visit: 4/12/2023 Posts: 10221 Rating: (1176)	Hi Did you sure that inside in CPU has program? regards

Suggestion To thank Quote Answer

10/8/2008 2:00 PM	Rate (0)
legacy support Silver Member Joined: 7/15/2008 Last visit: 4/21/2023 Posts: 382 Rating: (44)	Hello simatix I will ask the same Question as UMECHO , do you have a EPROM or RAM Module in your CPU ??. From your description I am assuming :NO If you have the Manual for the 928CPU , please look at Section 3 Page 32. ( Start Up and Functional Test . ) The 928CPU has NO Intenal Ram for the User Program , only for Data Blocks.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on