Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

WinCC and Allen Bradley

Created by: Hal Limmer at: 5/18/2007 3:57 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

5/18/2007 3:57 PM	Rate (0)
Hal Limmer Experienced Member Joined: 4/17/2007 Last visit: 7/26/2024 Posts: 47 Rating: (1)	Question: Does WinCC have a channel driver for Allen Bradley RSlogics? Or would you have to do this with OPC? Thanks for your help in advance. HJL

Suggestion To thank Quote Answer

5/18/2007 4:27 PM	Rate (0)
Danielle Posts: 1275 Rating: (123)	Hi, I've asked the moderator to transfer this thread to the WinCC forum... To communicate with Allen Bradley you should use OPC. Best regards, Danielle
Danielle Posts: 1275 Rating: (123)
Suggestion To thank Quote Answer

5/18/2007 4:46 PM	Rate (0)
Marcio R. Santos Silver Member Joined: 12/5/2005 Last visit: 12/9/2024 Posts: 239 Rating: (9)	Hi, Until the WinCC 5.1 was possible to implement the protocols DH+ AND DF1, but in version 6.0 and above is necessary to communicate using OPC, as commented by Danielle.
	Márcio Santos www.marcioroberto.wordpress.com
Suggestion To thank Quote Answer

5/19/2007 12:02 AM	Rate (0)
Hal Limmer Experienced Member Joined: 4/17/2007 Last visit: 7/26/2024 Posts: 47 Rating: (1)	Thanks, that is what I had thought, but I appreciate the answer... By the way...this may be a bit out of line...but you are beautiful... :) Thanks for the help!! HJL

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on