Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

WinCC Flexible 2008 change connection on PC

Created by: Raymondk at: 6/24/2009 3:21 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

6/24/2009 3:21 AM	Rate (0)
Raymondk Posts: 62 Rating: (0)	Hello Everyone, I am using WinCC Flexible 2008 for my project with RT on PC. the PC is connected to a S7300 redundant system. I have configured the change connection in WinCC Flex but i am only getting the connection changing in one direction. example from the Leading PLC to the standby PLC but not back from standby to Leading. I am using the work DB in step 7 in both PLC as the bit to create the change. I am manually switching the PLC to stop then back to run to test create the change over then the bit would change at the same type to indicate which PLC is leading. my work DB is DB5. I am using DB5.DBX9.1. If anyone can help to lead me in the right direction, please do. Thanks, Raymondk
Raymondk Posts: 62 Rating: (0)
Suggestion To thank Quote Answer

6/24/2009 9:00 AM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 9/13/2024 Posts: 8736 Rating: (1168)	Dear Raymondk, Have you seen this link: http://support.automation.siemens.com/WW/view/en/35508221 Perhaps it might help. Best regards, Wizard

Suggestion To thank Quote Answer

6/24/2009 1:47 PM	Rate (0)
Raymondk Posts: 62 Rating: (0)	Hello Wizard, Thank you for responding. I will look at the example in the link you directed me to and try again to see way i went wrong. Thank you, Raymondk
Raymondk Posts: 62 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on