Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

WinCC to CP1430TCP

Created by: wenbinz at: 5/18/2007 11:43 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

5/18/2007 11:43 AM	Rate (0)
wenbinz Posts: 7 Rating: (0)	Hi: I have very hard time to make the link of WinCC6.0 to S5 135 PLC by CP1613 and CP1430TCP. Please advise me the detail step by step. For the IP Address: what's the different between NDIS and CP1613? How can choose when configure winccapplication together with CP1613 in the NetPro configure?
wenbinz Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

5/21/2007 9:55 AM	Rate (0)
Ikkezelf Posts: 1084 Rating: (72)	Hi, Don't know about the CP1430TCP, but for the CP1613 you should not use/install NDIS. Read in the manual for the cp1613 card. It's written in there if I'm not mistaken. with regards, Ikkezelf
Ikkezelf Posts: 1084 Rating: (72)
Suggestion To thank Quote Answer

5/21/2007 11:20 AM	Rate (0)
J_Bell Posts: 5822 Rating: (412)	Hello, well, for connection WinCC V 6 to the S5 you need the PMC Channel by: http://www.industry.siemens.com/IT4Industry/EN/index.htm This allows you to access the S5 over Ethernet. You will have to purchase this add on for WinCC V 6. Please contact the IT4Industry team for more information. Best regards J_Bell
J_Bell Posts: 5822 Rating: (412)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on