Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

wincc trending problem!!!

Created by: mychinkee at: 3/9/2009 10:03 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

3/9/2009 10:03 AM	Rate (0)
mychinkee Posts: 14 Rating: (0)	Hi, I would like to know how should I configure the trending so that, when I can check on the Ruler function, thebottom showing value baris attached to my trending, and can't move? Thanks!
mychinkee Posts: 14 Rating: (0)
Suggestion To thank Quote Answer

3/9/2009 8:23 PM	Rate (0)
Phantom75 Posts: 2661 Rating: (278)	Hi mychinkee, You can do this using the AdjustRuler attribute. Whenever this attribute changes state, the ruler reverts back to original position. In addition you should also set the AnchorRuler attribute to yes. See attached screenshot. Regards Attachment TrendRuler.pdf (66 Downloads)
Phantom75 Posts: 2661 Rating: (278)
Suggestion To thank Quote Answer

3/10/2009 5:24 PM	Rate (0)
mychinkee Posts: 14 Rating: (0)	Thanks for your reply, but the problem is still there, attached for details. Once again thanks! Attachment TrendAllocate.JPG (57 Downloads)
mychinkee Posts: 14 Rating: (0)
Suggestion To thank Quote Answer

3/10/2009 10:07 PM	Rate (0)
Phantom75 Posts: 2661 Rating: (278)	When you toggle the AdjustRuler attribute the ruler window returns to its original position and size. Unfortunately the ruler window is not a separate object and so we cannot determine the position (or change of position) of this window. On the other hand if you toggle the AdjustRuler attribute all the time (with a pulse bit from PLC), you'll loose the ruler functionality completely. Hence the best solution (in my opinion) is to create a "restore position" button and using this button and an internal binary tag restore the ruler window position at will. Regards
Phantom75 Posts: 2661 Rating: (278)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on