Navigation

WinCC Unified PC v18 - communication freezes for 2-4 sec

Created by: Vovan75 at: 2/7/2023 11:16 AM (1 Replies)

2/7/2023 11:16 AM	Rate (0)
Vovan75 Member Joined: 6/5/2014 Last visit: 2/11/2023 Posts: 2 Rating: (0)	I have WinCC Unified PC v18, and have faced with same problem - communication freezes for 2-4 sec I found the solution: In Control Panel "Set PG/PC interface", access point S7Online was binded to Wi-fi Ethernet interface, but my PLC was on copper Eth. interface. I changed S7Online to correct interface, and communication works without freezes ------------------------------------------------------------------------------------------ Split from Wincc 7.0 SP3 Freezing Up While in Run time..
	Last edited by: Jen_Moderator at: 02/08/2023 05:54:28 New subject after splitting
Suggestion To thank Quote Answer
This contribution was helpful to 3 thankful Users Jen_Moderator Stefan Arcularius rdoliveira

2/8/2023 11:13 AM	Rate (0)
rdoliveira Gold Expert Joined: 4/26/2012 Last visit: 3/24/2023 Posts: 1245 Rating: (118)	Hello, you also have the option of viewing through the communication settings. good job. Attachment com.PNG (15 Downloads)
	Last edited by: rdoliveira at: 02/08/2023 11:14:35 "Always make a backup before and check the best time before testing." Obrigado.
Suggestion To thank Quote Answer
This contribution was helpful to 3 thankful Users Stefan Arcularius Jen_Moderator Vovan75