Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Wincc Unified simulation

Created by: MohamadBasha at: 4/23/2021 9:24 AM (2 Replies)

Rating (0)

Thanks 1

3 Entries

4/23/2021 9:24 AM	Rate (0)
MohamadBasha Advanced Member Joined: 7/25/2018 Last visit: 1/15/2023 Posts: 43 Rating: (0)	Hello everyone, I am a total new user of Wincc Unified and I am trying to simulate my 1200 Unified panel in my PC using the WinCC Unified web interface. But I keep getting the message "the validation of the parameter 'service' failed". I am using the user configured in WinCC Unified configuration wizard, and I made sure that all Windows services required are activated. Your help is highly appreciated. Attachment Capture.PNG (175 Downloads)
	Last edited by: MohamadBasha at: 04/23/2021 09:33:59 Regards, Mohamad
Suggestion To thank Quote Answer

4/23/2021 11:26 AM	Rate (0)
ro14 Experienced Expert Joined: 6/22/2020 Last visit: 1/26/2023 Posts: 100 Rating: (12)	Have you checked if all the required Windows functions are activated? See: https://support.industry.siemens.com/cs/ww/en/view/109773589

Suggestion To thank Quote Answer

4/23/2021 1:17 PM	Rate (0)
MohamadBasha Advanced Member Joined: 7/25/2018 Last visit: 1/15/2023 Posts: 43 Rating: (0)	Hello Ro14, Thanks for your reply. It turned out to be an update problem. It works fine now after using TIA16 Update 4.
	Regards, Mohamad
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users ZickZackTIA

|

Share this page:

Share this page on...

Related topics by keywords:

SIMATIC WinCC Unified

Follow us on