Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

WinCC Unified V17: How to turn off snap to grid function?

Created by: Plege2 at: 11/20/2023 9:21 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

11/20/2023 9:21 AM	Rate (0)
Plege2 Advanced Member Joined: 4/5/2021 Last visit: 12/1/2023 Posts: 17 Rating: (0)	Do you know how can I turn off this horrendous function? ------------------------------------------------------------------------------------------ Split from WinCC Unified V17 Snap to grid.
	Last edited by: Jen_Moderator at: 11/21/2023 07:12:55 New subject after splitting
Suggestion To thank Quote Answer

11/20/2023 9:57 AM	Rate (0)
Stefan Arcularius Platinum Expert Joined: 1/21/2013 Last visit: 12/5/2023 Posts: 2301 Rating: (371)	Hi Plege2, To change the snapping behavior in TIA Portal, open the settings (Options > Settings) and navigate to Visualization > Screens. There you will find the "Settings editor" section where you can change the snapping behavior. Note: Since these settings apply to all HMI devices you can select "Snap to grid" there which is not supported by WinCC Unified up to V18. Kind regards Stefan

Suggestion To thank Quote Answer

11/20/2023 10:12 AM	Rate (0)
Plege2 Advanced Member Joined: 4/5/2021 Last visit: 12/1/2023 Posts: 17 Rating: (0)	Thank You!! Stefan Arcularius Hi Plege2, To change the snapping behavior in TIA Portal, open the settings (Options > Settings) and navigate to Visualization > Screens. There you will find the "Settings editor" section where you can change the snapping behavior. Note: Since these settings apply to all HMI devices you can select "Snap to grid" there which is not supported by WinCC Unified up to V18. Kind regards Stefan

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on