Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

WinCC V13 KTP700 Simulation Crash

Created by: ndoell at: 9/3/2014 5:35 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

9/3/2014 5:35 PM	Rate (0)
ndoell Experienced Member Joined: 4/21/2012 Last visit: 1/9/2025 Posts: 10 Rating: (3)	The TIA Portal WinCC V13 Update 4 Basic Simulator does not work for me. If I open a new project, add a V13 HMI such as a KTP700 or KTP900, then try to Simulate, the Simulator crashes as soon as it opens. Any thoughts? Anyone else have this problem? Thanks, Attachment KTP700 Sim Crash 2014_08_0900.JPG (355 Downloads)
	Last edited by: ndoell at: 9/3/2014 5:37 PM
Suggestion To thank Quote Answer

9/4/2014 5:43 PM	Rate (0)
gj2sm Posts: 1 Rating: (0)	Same problem here on 2 systems but 2 others working correctly, not sure what the problem is at the moment.
gj2sm Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

9/30/2014 1:51 PM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published byAtymo is split to a separate thread with the subject WinCC V13 KTP700 no screens visible. Best regards Min_Moderator

Suggestion To thank Quote Answer

10/1/2014 3:46 PM	Rate (0)
JohnnyBoy22 Posts: 19 Rating: (1)	I've had similar problems in the past. Usually about a week into a project, I would receive messages like this on v13. I would have a lot of issues if my project was being saved to a remote file share. My suggestion would be to right click on the project and rebuild all. That usually cleared up everything. There was one occasion where I had to send the project to Siemens for correction. John
JohnnyBoy22 Posts: 19 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

TIA WinCC Installation Options General

Follow us on