Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

WinCC V6 Horn Delay

Created by: Wacky at: 4/25/2008 10:19 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

4/25/2008 10:19 AM	Rate (0)
Wacky Posts: 60 Rating: (2)	Hi everyone, I have the horn problem of WinCC 6.0 SP3. I have a pair of redundant WinCC servers and with few clients. The horn system is workable before. When alarm message was come, horn sounds on every station including servers and clients. After acknowledge the alarm, all stationgoes silent again. In recent, the horn sound was delayed! When a alarm come, no any horn sound. After a moment (let say 15min to half hour), the horn sound again. Any one have similar problem?
Wacky Posts: 60 Rating: (2)
Suggestion To thank Quote Answer

4/25/2008 2:30 PM	Rate (0)
BadBit Posts: 125 Rating: (26)	Hi, I dont know whats wrong, too. Maybe, this FAQ helps you: http://support.automation.siemens.com/WW/view/en/24845317 Regards
BadBit Posts: 125 Rating: (26)
Suggestion To thank Quote Answer

4/29/2008 9:15 AM	Rate (0)
Khaled_Ezzat Silver Member Joined: 9/7/2007 Last visit: 10/9/2024 Posts: 550 Rating: (62)	Hi does the delay occurs on all stations or part of them only if yes check the delayed station installed software and the hard ware requirements perhaps some thing has changed also
	Best Regards
Suggestion To thank Quote Answer

5/5/2008 3:10 PM	Rate (0)
Wacky Posts: 60 Rating: (2)	Khaled_Ezzat Hi does the delay occurs on all stations or part of them only if yes check the delayed station installed software and the hard ware requirements perhaps some thing has changed also All the servers and clients have same problem. I have used a internal tag to trigger the horn and I have built up the internal tag on all servers and clients, also with same horn configuration. It works for about 2 months and the problem suddenly came out.
Wacky Posts: 60 Rating: (2)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on