Hello forum users

On my project, there is some misunderstanding about moving from automating mode to manual of valves on Panel KP 700 Comfort. Here is how it works: when the panel's pushbutton is pressed, it should be changed the mode's positions. It works while I simulate on program itself, but it doesn't work on Panel. 

What kind of reasons may be caused for that?

P.S  Valve's signal is not connected to the module yet. 

Dear Xurshid,

can you take some screenshots, about your HMI tags, Event configuration, .. , for us?

Is the state of the moe saved in a plc tag or a HMI tag?

With best regards

rh1990

rh1990

Dear Xurshid,

can you take some screenshots, about your HMI tags, Event configuration, .. , for us?

Is the state of the moe saved in a plc tag or a HMI tag?

With best regards

rh1990

 ok, here you are

Dear Xurshid,

I can't see a failure. Do you set the tag in the PLC program? Can you delete the start values in DB?

rh1990

Dear Xurshid,

I can't see a failure. Do you set the tag in the PLC program? Can you delete the start values in DB?

 OK, I am going to try to do it and then I will inform you about it. Anyway, thanks for your answer.

Hello

Maybe you need "Rebuild all" software, and then download to panel?