WP231PE Calibration

Hello

I really can not understand how recalibration works in using WP231PE block. In 1.0 Recalibration page there is simple steps to recalibrate scale. I understand the first two steps to put scale into service mode and confirming that scale is empty.

When the calibration weight is has been loaded on scale how do you adjust the scale reading if it is different than the calibration weight. Reading in that page is only if I understand correctly observing purposes only.

Thanks Siwarexi for answer.

But my point is. If there is situation that calibration weight and scale reading is not same. Is there any possibility to adjust the second point of calibration using this WP231PE block ?

BR

Thanks for the answer Siwarexi.

Can you give me somekind of simple example how it is done? Probably I am missing here something

BR

Thanks Siwarexi for the ansewer.

Maybe I can not explain the problem clear enough.

In that step e). How do you change scale reading ?

If I have situation that scale zeroed and then there is calibration weight let's say 15000kg but scale is showing me 14500kg. How do I fix in step e) scale reading into 15000kg.

BR 

Thanks Siwarexi.

OK, so it is not possible to change the calibration weight with WP231PE block. In my case I have to use that block because the PR block is too large for my (1215).

Would that work that I would create alternative reading wich is scaled differently according to another calibration point wich is scaled in CPU not in scale. Would that create somekind of problem somewhere? or is there betters ways to have weightning setup in CPU?

BR