Navigation

PG / PC Interface does not show the access point CP-TCPIP

Created by: marco23 at: 4/30/2014 5:21 AM (1 Replies)

4/30/2014 5:21 AM	Rate (0)
marco23 Posts: 24 Rating: (0)	hi,I want WinCC Runtime Professional V.12 communicate with an S7-1200 PLC, but the option to set PG / PC Interface does not show the access point CP-TCPIP. Any suggestions, I need some driver? Under the following image. Attachment cp-tcpip.jpg (498 Downloads)
marco23 Posts: 24 Rating: (0)
Suggestion To thank

4/30/2014 1:27 PM	Rate (0)
GrasserF Posts: 340 Rating: (6)	Thread closed, because question is already published in the following thread access point CP-TCPIP interfae pg/pc
GrasserF Posts: 340 Rating: (6)
Suggestion To thank

Share this page:

Share this page on...