Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TIA portal and Start drive

Created by: Controls_Tech at: 4/6/2020 9:00 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

4/6/2020 9:00 PM	Rate (0)
Controls_Tech Posts: 20 Rating: (0)	Hello everyone, I have recently purchased TIA portal V16 and it also came with a start drive disk I have installed all the software and managed to do a bit of tinkering programming at my desk with a S7-1200, I can`t figure out how to get to start drive software, it did not create a shortcut but when I look in TIA portal >> Installed software it states that Sinamics start drive is installed. I do not have a inverter to configure yet I was just wanting to get use to the layout or perhaps use Simosim. I am just starting with Siemens software/hardware.Thanks in advance
Controls_Tech Posts: 20 Rating: (0)
Suggestion To thank Quote Answer

4/6/2020 9:43 PM	Rate (0)
Hati Platinum Member Joined: 9/21/2012 Last visit: 11/18/2024 Posts: 4199 Rating: (474)	Startdrive is integrated in TIA Portal. With Startdrive, you can configure Siemens drives to TIA projects.

Suggestion To thank Quote Answer

4/6/2020 9:48 PM	Rate (0)
Controls_Tech Posts: 20 Rating: (0)	Is there a way to access start drive without it detecting hardware?
Controls_Tech Posts: 20 Rating: (0)	Last edited by: Controls_Tech at: 04/06/2020 21:49:02
Suggestion To thank Quote Answer

4/7/2020 6:13 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 11/18/2024 Posts: 22453 Rating: (3030)	Hello, is the Online -> extended go online. here you can specifiy a IP which should be direct connected without search. But! SIMOSIM doesn't work with STARTDRIVE. SIMOSIM is the Simulation for SIMOTION D4x5-2 Controller, for that you need Scout TIA installed. Regards Christoph

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on