Is anyone else having issues with these sensors?

We have configured the Sensor to operate on a 0-10V DC signal for Rm Temp, Rm Stpt Adjustment & Rm Humidity.  The resistor has been clipped for readings in deg C.  The dip switch is set to Voltage and the jumper is set on 0-10V DC signal range.

Rm Temp & Rm Humidity Values read high on our Apogee Insight 3.14 graphics, or point log report. Values on the display, reflect the Rm Temperature and Rm Humidity in the space.

Adjusting the Rm Stpt Adjustment on the LED display operates fine, values read on Insight won't drop below 25.3 deg C.

The Sensor was ordered & received in May / June 2024 - Siemens Order # 1952666.

QFA32SS.FWSN

There is a manual at the link below

https://hit.sbt.siemens.com/RWD/app.aspx?RC=US&lang=en&MODULE=Catalog&ACTION=ShowProduct&KEY=S55622-H142

1. Temperature reads high
Page 2, right column shows three different output ranges.   The input range on the receiver (Apogee?) must match the output range on the thermostat, or the interpretation of the 0-10V signal will be incorrect.

2. Can't adjust Setpoint
top of page 2, right column shows a setting for Minimum Setpoint.
What's your thermostat set at for minimum SP?