Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Logo with KNX

Created by: Olov at: 10/10/2010 8:46 PM (3 Replies)

Rating (0)

Thanks 1

4 Entries

10/10/2010 8:46 PM	Rate (0)
Olov Posts: 3 Rating: (0)	Hello my name is Olov and i am a new member I have a problem with Logo and KNX the problem is not the KNX modul Ihave I12 lightrelay and clock, Q5 lamps out side ( working) then a have I13 wich is a input for my Alarm system it will light up my bedroom window lamps if iam not at home,the problem is when i come home I13 goes to 0 and Q8 will 0 The funtion a want is: If Q6 is 1 and I13 goes to 0 then Q6 stay at 1 and if Q6 is 0 stay at 0 Anyone understand plese help //Olov Attachment logo.jpg (618 Downloads)
Olov Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

10/12/2010 3:30 PM	Rate (0)
Andres [Str] Posts: 153 Rating: (16)	Hi_Olov You should simulate in an emulation mode in LOGO and to change logic of switching Attachment logo 1.jpg (587 Downloads)
Andres [Str] Posts: 153 Rating: (16)	Last edited by: Andrey [Str] at: 10/13/2010 7:47 AM Last edited by: Andrey [Str] at: 10/12/2010 3:38 PM
Suggestion To thank Quote Answer

10/12/2010 7:01 PM	Rate (0)
Olov Posts: 3 Rating: (0)	I have tried but i can´t find a solution //Olov
Olov Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

10/13/2010 10:32 PM	Rate (0)
Olov Posts: 3 Rating: (0)	Problem Ok thanks for help My solution //Olov Attachment logo3.jpg (509 Downloads)
Olov Posts: 3 Rating: (0)	Last edited by: Olov at: 10/13/2010 10:33 PM
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users O_Moderator

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on