SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Encoder interface

12/3/2010 9:58 AM	Rate (0)
ihui Posts: 17 Rating: (0)	Hallo, I have a question about the encoder interface configuration. There is an axis with a second encoder except the encoder on the motor. Simotion can get the second encoder value by profibus-dp. How can I configure this encoder in axis? From my understanding, there maybe two ways: ( Chapter 2.5.8 and Chapter 2.5.9 in Axis_TechnologyFct.pdf ) 1,configure encoder interface as a direct value in the I/O area; 2,configure a system variable to the encoder interface of axis and assign the encoder measuring value to the system variable. But I tried the first way and the axis can only be linear which is not acceptable in my case. Does anybody know why the axis can not be rotatory when the encoder value comes from I/O area? Are themethodsmentioned above both feasible? What's the difference between them when to solve my problem? Is there other way to use a DP interface encoder as the position feedback of axis? Looking forward to any recommendation. Thanks a lot!
ihui Posts: 17 Rating: (0)	Last edited by: ihui at: 12/3/2010 9:59 AM
Suggestion To thank Quote Answer

12/7/2010 7:51 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 9/2/2025 Posts: 22709 Rating: (3071)	Hello, when the encoder is configured via I/O then SIMOTION only supports linear characteristic for the analog I/O's. This configuration ist used when you have hydraulic sensors an use it as encoder of a axis. Which encoder do you use exactly? When the encoder have a DP Interface you can use telegram 81 for the encoder and with this telegram you can configure a axis or a external encoder in Scout. Or you use a telegram witch supports 2 encoder values (e.g. Telegram 106) so you can configure a axis with two encoder datasets. Regards Christoph

Suggestion To thank Quote Answer

12/7/2010 8:38 AM	Rate (0)
ihui Posts: 17 Rating: (0)	Thanks! You are always the one who gives people answers! I am using an encoder with DP interface and I will config it using telegram 81.
ihui Posts: 17 Rating: (0)
Suggestion To thank Quote Answer

12/7/2010 12:52 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 9/2/2025 Posts: 22709 Rating: (3071)	Hello, have you the model number of the encoder? So we can show if this encoder supports the telegram 81. egards Christoph

Suggestion To thank Quote Answer

12/14/2010 7:02 AM	Rate (0)
ihui Posts: 17 Rating: (0)	It's TR CE-65-M PROFIBUS. Thanks! Attachment CM-65-M PROFIBUS.pdf (428 Downloads)
ihui Posts: 17 Rating: (0)
Suggestion To thank Quote Answer

Share this page:

Share this page on...