12/16/2021 6:19 PM | |
Joined: 12/16/2021 Last visit: 1/8/2024 Posts: 7 Rating: (0) |
We have same problem for spindle motor servo enable when you command ------------------------------------------------------------------------------------------ |
Last edited by: Jen_Moderator at: 12/17/2021 06:18:02New subject after splitting |
|
12/17/2021 4:29 AM | |
Joined: 4/23/2010 Last visit: 12/31/2023 Posts: 8092 Rating: (876)
|
Hello Mdlpankak, Welcome to forum. Please open new topic to post your query instead posting it in old topic. In your case please refer your machine PLC logic to check why spindle drive servo enable signal i.e. DB3x.DBX2.1 gets reset, which trigers this alarm. Here x = spindle drive number. Hope this helps. |
This contribution was helpful to1 thankful Users |
1/7/2022 11:08 AM | |
Joined: 4/23/2010 Last visit: 12/31/2023 Posts: 8092 Rating: (876)
|
Hello Pankaj, Please refer my earlier reply & check the suggested signals in machine PLC logic which will help you to find out problem. Since this logic is developed by machine builder, you need to find it out & remotely not possible to pin out exact cause. Hope this helps. |
Follow us on