9/1/2023 2:11 PM | |
Joined: 4/28/2015 Last visit: 7/22/2024 Posts: 6 Rating:
|
Have a output coil "%q38.0:P" what does the ":P" represent? ------------------------------------------------------------------------------------------ |
Last edited by: Jen_Moderator at: 09/27/2023 12:18:12New subject after splitting |
|
9/27/2023 12:26 PM | |
Joined: 1/21/2013 Last visit: 9/12/2024 Posts: 3093 Rating:
|
Hi GeoBoni, The ":P" indicates peripheral access. Kind regards |
9/30/2023 7:10 AM | |
Joined: 4/28/2015 Last visit: 2/7/2024 Posts: 10533 Rating:
|
Hello,
in case of S7-x00 systems it can be access of areas outside of PI. Next situation can be right access at time to expected area and not wait to refresh of data due PLC scan. So it depends to PLC system you have but generally to more things configured. |
Last edited by: Duris_I at: 09/30/2023 07:11:22With best regards... |
|
10/6/2023 3:59 PM | |
Joined: 9/21/2012 Last visit: 9/12/2024 Posts: 4131 Rating:
|
Right click on the MOVE and you can see the selection. |
This contribution was helpful to
1 thankful Users |
Follow us on