Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Logo! 8 - onboard AI settings

Created by: Velesko at: 4/7/2021 10:14 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

4/7/2021 10:14 AM	Rate (0)
Velesko Posts: 18 Rating: (0)	Hello. I have a little question about AI settings on basic logo module. There is an option to make some Inputs as an analogue inputs (Enable 0 AIs; Enable 2 AIs - AI1 and AI2 as I7 and I8; Enable 4 AIs - AI1, AI2 as I7, I8 and AI3, AI4 as I1, I2). Is it possible to use, for example, I7 as AI1 for some analogue signal, but use I8 as a normal I8 input (if I will turn the option "Enable 2 AIs)? Thanks in advance.
Velesko Posts: 18 Rating: (0)	Last edited by: Velesko at: 04/07/2021 10:14:27
Suggestion To thank Quote Answer

4/7/2021 10:23 AM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 1/20/2026 Posts: 36494 Rating: (4552)	This is not a problem. You are not activating the analog input function, you are only reserving the first 2 AI addresses, AI1 and AI2. However, if you prefer to use terminal I8 as digital input I8, this is possible.

Suggestion To thank Quote Answer

4/7/2021 10:30 AM	Rate (0)
Scorp Platinum Member Joined: 2/22/2008 Last visit: 4/25/2025 Posts: 2698 Rating: (210)	In special applications it may be possible to use I1,I2,I7 and I8 for both analog/digital at the same time. The digital inputs are never disabled, low signal is <5V, high signal is >8.5V. Regards, Scorp

Suggestion To thank Quote Answer

4/7/2021 10:47 AM	Rate (0)
Velesko Posts: 18 Rating: (0)	Thank you all for a quick answers!
Velesko Posts: 18 Rating: (0)	Last edited by: Velesko at: 04/07/2021 10:48:27
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on