Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

horn isn't working after mounting a new PC and installing wincc on it

Created by: HSCD at: 9/26/2013 4:45 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

9/26/2013 4:45 PM	Rate (0)
HSCD Posts: 49 Rating: (0)	Dear all we have an external horn that is connected to a PLC DO. ther was a computer that wincc had been installed on that but the computer has been lost due to a fire in the building. The horn isn't working after mounting a new PC and installing wincc on it. could some one help me to find out the reason? Regards
HSCD Posts: 49 Rating: (0)	Last edited by: O_Moderator at: 9/27/2013 12:46 PM new subject after splitting from /tf/WW/en/Posts/93512#top
Suggestion To thank Quote Answer

10/10/2013 10:53 AM	Rate (0)
K!ke Posts: 1299 Rating: (136)	Hello, What do you mean by "horn isn't working?" Did you check if the horn itself is working? Do you get the command for horn from hmi? K!ke
K!ke Posts: 1299 Rating: (136)
Suggestion To thank Quote Answer

10/15/2013 8:13 PM	Rate (0)
HSCD Posts: 49 Rating: (0)	K!ke Hello, What do you mean by "horn isn't working?" Did you check if the horn itself is working? Do you get the command for horn from hmi? K!ke Dea k!ke we were a sound of the horn when an alarm or warning was showing up in hmi but after mounting a new PC that isn't working. the horn is working properly itself. I don't get nothing on PLC DO card. Regards
HSCD Posts: 49 Rating: (0)
Suggestion To thank Quote Answer

4/11/2021 1:51 AM	Rate (0)
OLD BREWERY Posts: 4 Rating: (0)	Hi, I hve the same problem now, but this topic was not resolved. Does anyone know what might be the problem?
OLD BREWERY Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

WinCC Installation Options General

Follow us on