Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Link between S7-PLCSIM ( ver5.4) and WincC

Created by: LeTien_BK88 at: 7/2/2021 11:53 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

7/2/2021 11:53 AM	Rate (0)
LeTien_BK88 Posts: 17 Rating: (0)	Hi everyone, I need your helps, Currently I am working with Step 7 ver5.6 Sp1 and WinCC Ver7.65 Sp1. I want to link between S7-PLC Sim and Winn CC. in Step 7, I already configured PLCSIM(TCP/IP) , In WInn I also configured Tag management under TCP/IP , Logical device of Unit tab has been configured to PLCSIM.TCPIP.1 at connection parameter. at step 7 I can check and modify logic with run -mode from PLCSim nomally but can't link to WInCC. Please refer to the picture attached Attachment 1.jpg (278 Downloads)
LeTien_BK88 Posts: 17 Rating: (0)	Last edited by: LeTien_BK88 at: 07/02/2021 11:54:43 Last edited by: LeTien_BK88 at: 07/02/2021 11:55:15
Suggestion To thank Quote Answer

7/2/2021 12:30 PM	Rate (0)
bg2492 Posts: 7298 Rating: (2188)	Hello LeTien_BK88, is the Slot Number 3 correct, this is the slot of the CPU ? You may remove the "hook" for "Set automatically" in the System Parameter TCPIP. Regards Georg Berghof
bg2492 Posts: 7298 Rating: (2188)
Suggestion To thank Quote Answer

7/5/2021 3:46 AM	Rate (0)
LeTien_BK88 Posts: 17 Rating: (0)	Hi, Thank you for your answer, Slot 3 is correct, could you please see the picture attached in HW configuration Attachment 2.jpg (208 Downloads)
LeTien_BK88 Posts: 17 Rating: (0)
Suggestion To thank Quote Answer

7/5/2021 4:07 AM	Rate (0)
LeTien_BK88 Posts: 17 Rating: (0)	Hi Bro! could you instruct me how to configure for these in Wincc. 7.5 please see the picture ! Thanks Attachment 4.jpg (244 Downloads)
LeTien_BK88 Posts: 17 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on