Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

WinCC migration

Created by: sufii at: 8/24/2021 9:14 AM (3 Replies)

Rating (0)

Thanks 1

4 Entries

8/24/2021 9:14 AM	Rate (0)
sufii Advanced Member Joined: 9/11/2017 Last visit: 9/16/2025 Posts: 10 Rating: (0)	Good Day! I have a WinCC 7.0 project, and I have to migrate it to WinCC 7.2. Unfortunately, the faceplates are not working after migration to 7.2, while in 7.0 they working fine. - I am using the WinCC migration tool. Any suggestions experts! Thanks in advance

Suggestion To thank

8/24/2021 9:20 AM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 1/15/2026 Posts: 36457 Rating: (4549)	And why post you not in the WinCC conference, but in the STEP5 conference?

Suggestion To thank
This contribution was helpful to 1 thankful Users Wit_Moderator

8/24/2021 9:32 AM	Rate (0)
sufii Advanced Member Joined: 9/11/2017 Last visit: 9/16/2025 Posts: 10 Rating: (0)	oh sorry, i will post there

Suggestion To thank

8/24/2021 10:07 AM	Rate (0)
Wit_Moderator Moderator Joined: 8/21/2014 Last visit: 12/19/2025 Posts: 1098 Rating: (15)	Closed, cause question posted twice. The second thread with the subject WinCC migration is published within the conference SIMATIC WinCC. Best regards The Helping Hand
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards Wit_Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on