Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

SICAM PAS SCC Command Issue

Created by: Eng.Abdo at: 2/14/2014 11:30 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

2/14/2014 11:30 PM	Rate (0)
Eng.Abdo Posts: 99 Rating: (0)	Dear All I am using SICAM PAS V7.02.02 SIMATIC WinCC V7.0 SP3 Upd 2 (Redundant HMI1 and 2) (RACK PC with Windows XP 2002 SP3) SICAM PAS V.01 SP2 HF3 (Station Unit 2.20 with Windows Embedded Standard SP3) (2 redundant server 1 and server 2) Problem Description; when I activate the run time of WinCC, and start to give command for any CB (open / close), it work fine and i receive the feed back of command execution and the status of the breaker change in the run time but after some time when i execute a command (open / close) for any CB, the command will be executed but no feed back nor status will change in the run time. if i deactivate and activate the run time again i will find the command executed already...... these problem happen so often please advise
Eng.Abdo Posts: 99 Rating: (0)
Suggestion To thank Quote Answer

2/25/2015 11:01 AM	Rate (0)
AutoGen_248108 Member Joined: 1/16/2013 Last visit: 7/6/2016 Posts: 1 Rating: (0)	hi contact Support.energy@siemens.com SCC is a product from Energy segment

Suggestion To thank Quote Answer

4/3/2022 7:49 AM	Rate (0)
Mstfbm Posts: 4 Rating: (0)	Hi I had a problem a little like your problem I want to know that both file on 2 HMI is same? if no please make them same and then check the problem
Mstfbm Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

WinCC Communication (OPC, S7, OtherSystem)

Follow us on