Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Got error "E_Fail OPCBrowse.Browse" for S7-200Smart.OPCServer

Created by: wincc_PG at: 4/2/2022 2:13 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

4/2/2022 2:13 PM	Rate (0)
wincc_PG Regular Member Joined: 4/19/2020 Last visit: 4/29/2025 Posts: 4 Rating: (0)	I am facing same problem ------------------------------------------------------------------------------------------ Split from Configuring PC Access OPC server + WinCC for S7 200 ST60
	Last edited by: Jen_Moderator at: 04/04/2022 11:40:53 New subject after splitting.
Suggestion To thank Quote Answer

4/2/2022 3:16 PM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 1/21/2026 Posts: 12481 Rating: (2722)	Hello nikss; What is the part number of the PC Access SMART OPC server you are using in this project? PC Access was developped for the S7-200 PLC family, not the S7-200 SMART. See the following video shwing hw they conncect WinCC v7.5 to a s7-200 SMART through OPC, maybe it can offer helpful suggestions. Hope this helps, Danie Chartier

Suggestion To thank Quote Answer

4/3/2022 8:56 PM	Rate (0)
wincc_PG Regular Member Joined: 4/19/2020 Last visit: 4/29/2025 Posts: 4 Rating: (0)	I am using Wincc 7.4 sp1 update 14 pc access smart 2.3 microwin/smart 2.5 and getting same issue

Suggestion To thank Quote Answer

4/3/2022 8:58 PM	Rate (0)
wincc_PG Regular Member Joined: 4/19/2020 Last visit: 4/29/2025 Posts: 4 Rating: (0)	In OPC scout 10 i have got error "E_Fail OPCBrowse.Browse" for S7200Smart.OPCServer

Suggestion To thank Quote Answer

4/5/2022 12:49 PM	Rate (0)
Murof Platinum Expert Joined: 8/3/2009 Last visit: 1/21/2026 Posts: 16653 Rating: (1944)	Hello Check this FAQ, perhaps it helps: https://support.industry.siemens.com/cs/de/en/view/21915573 Bye Murof
	If this Information really helps, you could use the Rate function
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on