Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

field current trace

Created by: sh63 at: 5/13/2009 5:57 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

5/13/2009 5:57 AM	Rate (0)
sh63 Posts: 22 Rating: (0)	Dear sir, How I can trace field current for simodrive 611 u by simocom software? Thanks alot
sh63 Posts: 22 Rating: (0)
Suggestion To thank Quote Answer

5/27/2009 9:09 PM	Rate (0)
Dave Posts: 271 Rating: (29)	Hello Farzinfard, I have never had to measure field current within 611U; however, I see that if you select expert mode for the analog outputs there is a selection for "Field-generating current actual value Id" (i.e., P633=4). This may give you what you're looking for. Hope this helps...
Dave Posts: 271 Rating: (29)	Last edited by: Dave at: 5/27/2009 9:09 PM
Suggestion To thank Quote Answer

6/4/2009 10:38 AM	Rate (0)
sh63 Posts: 22 Rating: (0)	Hello, thank you for your answer,what is different between motor current and torque generation current that we see in simocom software? because motor current is most higher than torque generation current. thanks alot
sh63 Posts: 22 Rating: (0)
Suggestion To thank Quote Answer

6/4/2009 9:54 PM	Rate (0)
Dave Posts: 271 Rating: (29)	Hello Farzinfard, There are two currents for an induction motor. Id is the field generating current and Iq is the torque generating current. The motor current is the vectoral summation of these two currents. Hope this helps...
Dave Posts: 271 Rating: (29)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on