Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

S7-SCL V 5.3 with Windows Xp SP3

Created by: S44 at: 2/28/2011 11:23 AM (2 Replies)

Rating (1)

Thanks 2

3 Entries

2/28/2011 11:23 AM	Rate (0)
S44 Posts: 123 Rating: (4)	Hi, I am facing a problem with SCL V5.3 if i try to open a SCL source in my computer, it doesn't open and i get this message :The specified value was not found under the given key in the Windows registry (see attachment) I check the compatibility of SCL and windows: it seams that SCL v5.3 is supported by Win XP SP1 and SP2 only. but one of my collegue is running it on winxp sp3 without problems! also in license manager, in software installed, scl doesn't appears, but it is installed! i also tryed to repare it , if anyone has a solution for that! or know what to enter in the registry of windows thanks in advance sylvain Attachment SCL message.JPG (349 Downloads)
S44 Posts: 123 Rating: (4)
Suggestion To thank Quote Answer

2/28/2011 11:41 AM	Rate (1)
Chilly_Garfield Posts: 316 Rating: (37)	Hi syl20, I think you have this possibilities to correct the failure: - reorganize your project (SIMATIC MANAGER --> File --> Save as --> "With reorganization") -update SCL toSP5 - or deinstall and install SCL (no repaire) Did one possibility solve your problem?
Chilly_Garfield Posts: 316 Rating: (37)	Last edited by: Chilly_Garfield at: 2/28/2011 11:41 AM
Suggestion To thank Quote Answer

2/28/2011 1:01 PM	Rate (0)
S44 Posts: 123 Rating: (4)	Hi garfield, thanks for your message! i tryed to uninstall and reinstall the softtware, but doesn't work then I have updated to SCL SP5, and it is ok now! all my sources blocks can be edited! have a nice week! Sylvain
S44 Posts: 123 Rating: (4)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users O_Moderator Chilly_Garfield

|

Share this page:

Share this page on...

Follow us on