Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

AK 1703 IEC104 Master&Slave

Created by: claud84 at: 9/10/2013 12:26 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

9/10/2013 12:26 PM	Rate (0)
claud84 Posts: 8 Rating: (0)	Hello, I need to programm an AK1703 to function as both master and slave on the iec104 protocol. I need to get signals from a iec104 slave device and route them to a IEC104 master. I have done TOOLBOX project before but i haven't face this problem. Can someone give me a hint or some indications , documentation on how to do this? Thank you!
claud84 Posts: 8 Rating: (0)
Suggestion To thank Quote Answer

11/5/2013 1:10 PM	Rate (0)
ensark2 Bronze Member Joined: 11/18/2009 Last visit: 12/31/2025 Posts: 263 Rating: (18)	I have done same with IEC101. IEC101 master forward date to IEC101 slave. It does ti automatically. I didn't have much data so I have LNK and SIG for CAEx so I could follow values of signals. br Ensar

Suggestion To thank Quote Answer

11/5/2013 1:15 PM	Rate (0)
rchie Posts: 36 Rating: (2)	if you use the same protocol element card to act as master and slave, it is difficult to do and can cause flooding. but if really require you can use sdfr and indicate the source BSE, SSE, SID and disable automatic dataflow routing in topology.
rchie Posts: 36 Rating: (2)
Suggestion To thank Quote Answer

1/28/2014 4:52 PM	Rate (0)
bthompson Posts: 1 Rating: (0)	I need to communicate between AK1703 and DNP3 master. Any assistance available on ToolBox configuration for this ? .
bthompson Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on