Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Hooking ET200U modules to a 414-4H processor

Created by: andreas@spencerengineering at: 10/2/2007 9:47 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/2/2007 9:47 PM	Rate (0)
andreas@spenceren... Advanced Member Joined: 10/2/2007 Last visit: 9/12/2025 Posts: 1 Rating: (0)	We replace an old redundant S5 systemwith a new redundant S7 system using the 414-4H CPU's. Is it possible to reuse the old ET200U modules? If so how do you configure them? Thanks

Suggestion To thank Quote Answer

10/3/2007 5:31 PM	Rate (0)
Denilson Pegaia Platinum Member Joined: 9/23/2005 Last visit: 9/10/2025 Posts: 4416 Rating: (1485)	Hi, I'm not sure if it really homologate, but if there is a solution this is with the use of a Y-coupler.
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

10/3/2007 11:29 PM	Rate (0)
J_Bell Posts: 5822 Rating: (412)	Hello, yes, the Y-Link or Y-Coupler are the unit of choice in this situation. Best regards J_Bell
J_Bell Posts: 5822 Rating: (412)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on