Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

TIA portal 10.5, save uploaded program from S7-1200

Created by: AlecTek at: 6/1/2011 12:22 AM (3 Replies)

Rating (2)

Thanks 1

4 Entries

6/1/2011 12:22 AM	Rate (0)
AlecTek Posts: 95 Rating: (0)	We have a system: S7-1200 + KTP600. I already know that I cannot upload HMI, but I can upload S7-1200 program. I create an empty project with asame PLC configuration, I go online and a short time all the program is uploaded under program blocks. However, I saved the project and I open itagain, the program blocks are empty, just as the new created one. Please tell me why this happens and how to save the program?
AlecTek Posts: 95 Rating: (0)
Suggestion To thank Quote Answer

6/1/2011 1:37 AM	Rate (2)
primus 1 Posts: 45 Rating: (4)	Hello I caught this in the Step 7 v10.5 manual p.534 hope it helps. Loading blocks from an accessible deviceRequirement• The accessible devices are displayed. See also: Displaying accessible devices (Page 1533)• The PLC folder in the project contains no data. Procedure To upload blocks from an accessible device to your project, follow these steps: 1. In the project tree, drag the "Program blocks" folder of the accessible device to the "Program blocks"folder of the PLC in the project.The "Upload preview" dialog box opens. This dialog displays messages and proposes actionsnecessary for uploading. If the PLC folder in the project already contains data, a message informsyou that these data will be replaced. 2. Check the messages and, where necessary, enable the actions in the "Action" column. 3. As soon as uploading becomes possible, the "Upload from device" button is enabled. 4. Click the "Upload from device" button. Tom
primus 1 Posts: 45 Rating: (4)	Last edited by: primus 1 at: 6/1/2011 11:05 AM Last edited by: primus 1 at: 6/1/2011 11:03 AM Last edited by: primus 1 at: 6/1/2011 1:38 AM
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users AlecTek

6/1/2011 8:02 PM	Rate (0)
AlecTek Posts: 95 Rating: (0)	Thanks, it works Best regards
AlecTek Posts: 95 Rating: (0)	Last edited by: AlecTek at: 6/1/2011 8:02 PM
Suggestion To thank Quote Answer

10/13/2014 6:31 AM	Rate (0)
Sanju85 Posts: 2 Rating: (0)	Yesterday I had the same problem, and your post helped me. But while copying, I found some data missing in the PLC program . Then I had to compare it with the accessible device program and made the required changes. I dont know why !!! If you have any answer, please reply. Thanks...
Sanju85 Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on