Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Deleting tags in WinCC

Created by: RaGud at: 2/20/2008 10:56 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

2/20/2008 10:56 AM	Rate (0)
RaGud Posts: 46 Rating: (1)	Hi, I am sorry to post such an elementary question. How do I delete tags in WinCC that were originally created in Step7? I have to admit, I did find this out couple of years ago but have not had to use it since. Thus, all is forgotten! I am using Step7 V5.3 and V5.4. Please don't tell me to go and read a 500 pg. manual that is written for much earlier versions of s/w. If you have a page number/reference, fine. I have already read few threads regarding the subject but the procedures do not seem to match my Step7. At least I can't find the tools needed to carry out the procedure. Hopeful for a good (and ***proof) explanation. Best regards, Ragud
RaGud Posts: 46 Rating: (1)
Suggestion To thank Quote Answer

2/21/2008 12:28 PM	Rate (0)
April Posts: 1776 Rating: (95)	Hi, a small FAQ to read http://support.automation.siemens.com/WW/view/en/23183376 use WinCC Configuration Tool
April Posts: 1776 Rating: (95)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on