Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

WinCC Runtime Disconnection

Created by: Mak4Siemens at: 12/28/2007 4:10 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

12/28/2007 4:10 PM	Rate (0)
Mak4Siemens Posts: 28 Rating: (0)	Hi forum, 1. Is it possible to disconnect WinCC runtime from Station. And to connect it again? 2. Is it possible to change station address dynamically from the script when WinCC is in Runtime? Thanks
Mak4Siemens Posts: 28 Rating: (0)
Suggestion To thank Quote Answer

1/7/2008 12:00 PM	Rate (0)
Danielle Posts: 1275 Rating: (123)	Hi, Once you start runtime the application will start communication... I've never heard of any way to simply stop communication with a certain controller.. The station's IP is defined in Windows... so you'd have to access the right communication processor's properties from Windows... I'm not sure if this can be done, though... first of all you should test changing this manually while WinCC runtime is running, and check if it wouldn't lose communication... Once again, I don't really think this can be done... do you really need this feature? Usually this kind of changes aren't common, and performed with runtime off... Best regards, Danielle
Danielle Posts: 1275 Rating: (123)
Suggestion To thank Quote Answer

4/26/2008 3:22 PM	Rate (0)
Khaled_Ezzat Gold Member Joined: 9/7/2007 Last visit: 4/3/2025 Posts: 550 Rating: (62)	take care from the side effects!!! you may lose the communication forever
	Best Regards
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on