CPU 1510SP F-1 PN local io modules input/output data not available

I have a CPU 1510SP F-1 PN with various safe and non-safe local io.  Everything compiles correctly and downloads.  With the PLC in stop all modules have a green check.  However when the PLC is switched to run all io modules switch to "input/output data not available" and return no data to the plc.

If I perform a CPU memory reset they go back to a green check.

The help states "No input or output data are available, because the (sub)module has blocked its input or output channels." but does not offer any suggestions why.

I am stumped.  I have modified the hardware config to force a recompile, wiped the PLC and memory card and then downloaded a new config.  My next step is to just start from scratch, but I already have all my safety io configured.

Here are some pastes from the diagnostics buffer:

Diagnostics buffer of the module PLC_Main [CPU 1510SP F-1 PN]


Article no. / name            Component                     Version
6ES7 510-1SJ00-0AB0           Hardware                      1
- - -                         Firmware                      V 1.7.0
Firmware expansion            Firmware expansion            ---


Rack:                         0
Slot:                         1

13 of 344; Event ID: 16# 02:3958
Error: User data failure of hardware component - 
 
 PLC_Main / DI 16x24VDC ST_1.

Incoming event
2/17/2015 12:25:15.254 PM


14 of 344; Event ID: 16# 02:400E
CPU info: Communication initiated request: WARM RESTART
Pending startup inhibit(s):
 - No startup inhibit set
 
 CPU changes from STARTUP to RUN mode

 PLC_Main

Incoming event
2/17/2015 12:25:15.240 PM

Hi,

Maybe the configured card types are not matching with real cards in the slots.

"13 of 344; Event ID: 16# 02:3958
Error: User data failure of hardware component -  "

It worth a double check! Keep us posted!

PS: I found an interesting entry maybe any use:

https://support.industry.siemens.com/cs/us/en/view/69063762

After struggling with this for a few days, I did finally resolve this issue at the end of the day, a few hours after my post.

I took a screen shot of the io layout list, deleted all the io modules but left the CPU.  I then reinserted the io modules, set the addressing, set the safety parameters and downloaded.  I had to change some of the io safety addresses online as they changed during the rebuild.

Everything works just as it should.

One other thing I did is delete the X1.P1 and P2 bus adapter as I am not using one and have those ports disabled.  The only option in the hardware library was to insert the CPU with a bus adapter.  However, I went back to my old project, tried only deleting the bus adapter and it had no effect.

Just something corrupted I guess.

Hi,

i just got the same error in my configuration, but I managed to find the solution as well. 

My problem was that I did not used the correct base for the et200sp island. 

When I changed the dark base to the light base (new potential group), the error was gone. 

Hope this helps...

iwein

hii

i fund this type of error please suggest proper solution.

manisha12

hii

i fund this type of error please suggest proper solution.

 more detailed informations need!

IweinClaerhout

Hi,

i just got the same error in my configuration, but I managed to find the solution as well. 

My problem was that I did not used the correct base for the et200sp island. 

When I changed the dark base to the light base (new potential group), the error was gone. 

Hope this helps...

iwein

 Thank you, this saved my @ss today. Why oh why can't the error code say "incorrect base module fitted" ?