Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

step7 compiling safety blocks error

Created by: radu.ch at: 12/9/2021 3:21 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

12/9/2021 3:21 PM	Rate (0)
radu.ch Posts: 40 Rating: (0)	There are no more available numbers for the Function Block you are creating. I had this error while trying to compile my safety blocks in the project . using step7 V5.5
radu.ch Posts: 40 Rating: (0)
Suggestion To thank Quote Answer

12/9/2021 4:11 PM	Rate (0)
Towome Platinum Expert Joined: 7/9/2015 Last visit: 12/17/2025 Posts: 4493 Rating: (644)	Hi radu.ch, did you get any error code with this message or do you have a screenshot of the mesage? Regards, Towome
	If my post was useful, please rate me - if not, please tell me - thank you!
Suggestion To thank Quote Answer

12/10/2021 7:46 AM	Rate (0)
radu.ch Posts: 40 Rating: (0)	This is the error that I am getting, at the compilation of the safety blocks.
radu.ch Posts: 40 Rating: (0)
Suggestion To thank Quote Answer

12/10/2021 8:55 AM	Rate (0)
Towome Platinum Expert Joined: 7/9/2015 Last visit: 12/17/2025 Posts: 4493 Rating: (644)	Hi radu.ch, The message appears if the number range of the F data blocks in the F parameters of the CPU was set too low. Please check Screenshot. When generating the safety program, F-blocks are automatically added in order to generate an executable safety program from the safety program you have programmed. For the automatically added F-data blocks, you must reserve a number range here. You specify the first and the last number of the number band. Regards, Towome Attachment Datablock.PNG (598 Downloads)
	Last edited by: Towome at: 12/10/2021 08:55:39 Last edited by: Towome at: 12/10/2021 08:56:12 If my post was useful, please rate me - if not, please tell me - thank you!
Suggestion To thank Quote Answer

12/10/2021 11:34 AM	Rate (0)
radu.ch Posts: 40 Rating: (0)	Thanks a lot! This helped me.
radu.ch Posts: 40 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on