Navigation

Is it possible to monitor actual torque with following method in S7-1500?

Created by: moorthy007 at: 1/9/2023 12:27 PM (1 Replies)

1/9/2023 12:27 PM	Rate (0)
moorthy007 Member Joined: 3/19/2022 Last visit: 9/6/2025 Posts: 1 Rating: (0)	Technology Team Hello, with S7-1200 TO doesn't support Tel. 750. You have to provide applicative M_LIMIT_POS and M_LIMIT_NEG with 100% (4000 hex). When it is 0, the torque limits inV90 are 0, because P1522 and P1523. it is possible to monitor actual torque using this method in s7 1500 ------------------------------------------------------------------------------------------ Split from Sub telegram 750 not working in V90 servo with 1200 PLC (speed control mode).
	Last edited by: Jen_Moderator at: 01/09/2023 13:10:33 New subject after splitting
Suggestion To thank Quote Answer

1/9/2023 1:57 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 1/14/2026 Posts: 6066 Rating: (828)	yes, with S7-15OO, Telegramm extension 750 includes Torque values
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer