Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Not able to 'Go Online'

Created by: Kaayaa at: 12/4/2023 8:18 PM (3 Replies)

Rating (0)

Thanks 1

4 Entries

12/4/2023 8:18 PM	Rate (0)
Kaayaa Joined: 4/5/2023 Last visit: 1/15/2025 Posts: 34 Rating: (0)	Hi, I'm using CPU 1214 ac/dc module, FW is 4.2. IP address PC 192.168.0.1 Device 192.168.0.201 They are in same subnet. When I try to connect with device using ethernet, it gives me attached error. What can I do to work this out? Attachment Screenshot 2023-12-04 101248.png (240 Downloads)

Suggestion To thank Quote Answer

12/4/2023 9:39 PM	Rate (0)
0_Einstein Grandmaster-Expert Joined: 7/7/2010 Last visit: 12/31/2025 Posts: 16342 Rating: (2521)	Update the firmware of your PLC to at least 4.2, or drop the project PLC's firmware to match the actual hardware (assuming it is FW v4.2). Kaayaa Hi, I'm using CPU 1214 ac/dc module, FW is 4.2. IP address PC 192.168.0.1 Device 192.168.0.201 They are in same subnet. When I try to connect with device using ethernet, it gives me attached error. What can I do to work this out?
	Last edited by: 0_Einstein at: 12/04/2023 21:40:39 science guy
Suggestion To thank Quote Answer

12/5/2023 1:06 PM	Rate (0)
Kaayaa Joined: 4/5/2023 Last visit: 1/15/2025 Posts: 34 Rating: (0)	How to update firmware of PLC?
	Last edited by: Kaayaa at: 12/05/2023 15:02:30
Suggestion To thank Quote Answer

12/5/2023 5:40 PM	Rate (0)
Kaayaa Joined: 4/5/2023 Last visit: 1/15/2025 Posts: 34 Rating: (0)	I am able to upload a program now. Thanks,

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users 0_Einstein

|

Share this page:

Share this page on...

Follow us on