Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Setbit HMI problem

Created by: Assylum at: 6/5/2014 10:06 AM (16 Replies)

Rating (1)

Thanks 2

Result pages:: |; 1 | 2; |

17 Entries

Entries per page: 10 | all

6/5/2014 1:19 PM	Rate (0)
Assylum Posts: 8 Rating: (1)	Hello, it is not used, because it is just a probe variable. When I add a new tag, TIA gives a new address to the tag. So it is a lonely tag only for testing this function. BR, Asslum
Assylum Posts: 8 Rating: (1)
Suggestion To thank Quote Answer

6/5/2014 2:12 PM	Rate (0)
desmul24 Posts: 378 Rating: (73)	Hello, I agree with Wizard's suggestions. Please double check M106.0 is not used in your PLC check with another (unused) marker variable . Another problem could be on your HMI tag properties, you might set the acquisition cycle too high. Rgs,
desmul24 Posts: 378 Rating: (73)
Suggestion To thank Quote Answer

6/5/2014 3:09 PM	Rate (0)
Assylum Posts: 8 Rating: (1)	Hello, As I said it is just a probe bit and TIA gave it a new unused address. I checked the aqu. time, but that is not the problem. And for other bits it works.... But I think it is cannot be solved remote, so thank you for the help! BR, Assylum
Assylum Posts: 8 Rating: (1)
Suggestion To thank Quote Answer

6/5/2014 3:43 PM	Rate (0)
0_Einstein Grandmaster-Expert Joined: 7/7/2010 Last visit: 12/23/2025 Posts: 16325 Rating: (2520)	Assylum Hello, As I said it is just a probe bit and TIA gave it a new unused address. I checked the aqu. time, but that is not the problem. And for other bits it works.... But I think it is cannot be solved remote, so thank you for the help! BR, Assylum Use a different address manually that you know is not used. Say M1234.0 or something equally high and not likely used.
	science guy
Suggestion To thank Quote Answer

6/6/2014 1:09 PM	Rate (0)
m_turk Posts: 25 Rating: (0)	Just put the addressing to absolute, it will work...
m_turk Posts: 25 Rating: (0)
Suggestion To thank Quote Answer

6/6/2014 1:39 PM	Rate (1)
Assylum Posts: 8 Rating: (1)	Hi All, Idont use the memory bit anymore, I rather use a DB variable and now it works fine. Thanks for the comment! BR, Assylum
Assylum Posts: 8 Rating: (1)	Last edited by: Assylum at: 6/6/2014 1:39 PM
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users 0_Einstein

1/22/2024 10:47 AM	Rate (0)
AutoGen_1978707 Posts: 1 Rating: (0)	Nobody answered the question. I changed all memory bits to DB bits , now it works. But it is too bad that nobody knows anything about solving this issue.
AutoGen_1978707 Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on