Navigation

Sinamics DCM not enough torque

Created by: safrygin.v at: 1/15/2024 5:49 AM (1 Replies)

1/15/2024 5:49 AM	Rate (0)
safrygin.v Posts: 1 Rating: (0)	Hello! we use 6RA80 at mine hoisting machine, closed-loop speed control. when it starts at low speed (around 0.01%) it's not rotate, so i think there is not enough torque. is it possible to increase torque at low speed? Thank you!
safrygin.v Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

1/25/2024 8:45 AM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 12/22/2025 Posts: 6062 Rating: (828)	Hi safrigin.v, At first I would check the setpoint an releases ... Check the limits Current /Torque Is the brake open? Check the brake control. Make trace with actual speed and speed stpoint, controlword and status word, torque(current)setpoint and torque(current)act value. Safe the project and open a Service Request in the customer support
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer