Navigation

transfer of actual db values from STEP 7 to TIA portal

Created by: AutoGen_6284790 at: 2/5/2024 1:34 PM (1 Replies)

2/5/2024 1:34 PM	Rate (0)
AutoGen_6284790 Joined: 4/23/2023 Last visit: 11/16/2025 Posts: 4 Rating: (0)	Good afternoon! I have an upload of a 300 series controller programme that needs to be converted to TIA portal. The problem is that I need to transfer the actual values of the data blocks into a new TIA portal project and load them into the PLC. Is there any way to do this? Thank you all in advance for your replies.

Suggestion To thank Quote Answer

2/5/2024 2:46 PM	Rate (0)
Towome Platinum Expert Joined: 7/9/2015 Last visit: 12/17/2025 Posts: 4493 Rating: (644)	Hi, with Simatic Manager it´s a little bit tricky but there are two solutions to save the actual avlues of a data block. Please check this FAQ: What is the significance of the initial and actual values of a data block in STEP 7 V5.x? Regards, Towome
	If my post was useful, please rate me - if not, please tell me - thank you!
Suggestion To thank Quote Answer