DINT TO TIME OR TIMER UNIT CHANGE??

Hello everybody!

Im working in an application were I enter a time in seconds into an HMI and I have to set it as an entrance to a couple timers. The program works fine up to 32 seconds, but whenever I try to use 33 seconds or higher values, it all messes up. I get the value from HMI and multiply it to 1000 to get it into miliseconds, but it seems to fail when I use values above 33, in the multiply number it's too big for a dint so it gives me a negative value, so when I introduce it to a timer, it all messes up.

I have two questions, is there any way to convert a DINT into a TIME?

Is it possible to change the unit of a timer from miliseconds into seconds??

Thanks in advance!

Please don't post twice for the same problem.

Closed cause question posted twice.

The second thread with the subject Dint to Time? Timer unit change? is published within the conference STEP 7 (TIA Portal).