Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Value status of digital I/O modules

Created by: kosta_nk at: 12/16/2024 3:09 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

12/16/2024 3:09 PM	Rate (0)
kosta_nk Advanced Member Joined: 3/30/2010 Last visit: 3/4/2025 Posts: 12 Rating: (0)	Hello, I encountered a strange problem. In one project I read value status from digital input and output modules and all bits are 1 "no fault". Interface module is "IM 155-6 PN ST", digital input modules are "DI8x24VDC ST" and digital output modules are "DQ8x24VDC/0.5A ST". A CPU is "CPU 1515-2 PN". In another project value statuses are always 0, though all input/output signals are read/written correctly. Interface module is different "IM 155-6 PN/2 HF", digital input and output modules are the same "DI8x24VDC ST", "DQ8x24VDC/0.5A ST". A CPU is "CPU 1517-3 PN/DP". TIA Portal 18 Update 3. Did anyone meet anything similar?

Suggestion To thank Quote Answer

12/18/2024 10:43 AM	Rate (0)
JBS98 Regular Member Joined: 7/19/2022 Last visit: 9/11/2025 Posts: 436 Rating: (72)	Hello kosta_nk, Check that none of the possible scenarios occur for the value status can be 0: SIMATIC ET 200SP Distributed I/O system: Value status
	Last edited by: JBS98 at: 12/18/2024 10:44:06 If this Information really helps, you could use the Rate function Best Regards, JBS98
Suggestion To thank Quote Answer

12/19/2024 5:04 PM	Rate (0)
0_Einstein Diamond Expert Joined: 7/7/2010 Last visit: 9/12/2025 Posts: 16094 Rating: (2515)	I am probably wrong, but in the always 0 project, verify diagnostics are enabled for the I/O modules and IM155-6PN/2 HF kosta_nk Hello, I encountered a strange problem. In one project I read value status from digital input and output modules and all bits are 1 "no fault". Interface module is "IM 155-6 PN ST", digital input modules are "DI8x24VDC ST" and digital output modules are "DQ8x24VDC/0.5A ST". A CPU is "CPU 1515-2 PN". In another project value statuses are always 0, though all input/output signals are read/written correctly. Interface module is different "IM 155-6 PN/2 HF", digital input and output modules are the same "DI8x24VDC ST", "DQ8x24VDC/0.5A ST". A CPU is "CPU 1517-3 PN/DP". TIA Portal 18 Update 3. Did anyone meet anything similar?
	science guy
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on