Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Hardware component missing or removed error

Created by: AutoGen_7651895 at: 1/22/2025 1:06 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

1/22/2025 1:06 AM	Rate (0)
AutoGen_7651895 Joined: 2/6/2024 Last visit: 2/11/2025 Posts: 9 Rating: (1)	So I use a 6ES7 677-2SBx2-0xB0 PC. But it cannot see the IO cards attached. I tried to re-attach them, hardware config, change parts. But the PLC just doesnt seem to be able to find the IO cards. All of them has the LED on for power, and the DI cards do light up with the Inputs thats reciving a signal. Anything I can do against this? Attachment forum.PNG (105 Downloads)

Suggestion To thank Quote Answer

1/22/2025 10:08 AM	Rate (0)
Havillant Comet Silver Expert Joined: 8/6/2018 Last visit: 9/3/2025 Posts: 366 Rating: (46)	Hello, can you send us the diagnostic buffer in txt? Thanks you

Suggestion To thank Quote Answer

1/22/2025 12:13 PM	Rate (0)
AutoGen_7651895 Joined: 2/6/2024 Last visit: 2/11/2025 Posts: 9 Rating: (1)	this is from the buffer Attachment forum.PNG (98 Downloads)

Suggestion To thank Quote Answer

1/22/2025 4:56 PM	Rate (0)
AutoGen_7651895 Joined: 2/6/2024 Last visit: 2/11/2025 Posts: 9 Rating: (1)	I found the solution. The IO card where lose. Pushed it in and the error disappeared

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on