Navigation

TIA v20 Error occured during setup - FAQ 14667

Created by: plcspace at: 5/2/2025 3:20 PM (1 Replies)

5/2/2025 3:20 PM	Rate (0)
plcspace Member Joined: 3/6/2020 Last visit: 7/3/2025 Posts: 40 Rating: (0)	I use PG M4 and I installed new version of Win10 (there was no other software, just bare Windows and all updates) I have Edition Windows 10 Pro Version 22H2 Installed on ‎26/‎04/‎2025 OS build 19045.5796 Experience Windows Feature Experience Pack 1000.19061.1000.0 There is log [attached] Could you tell me what mean: "AdsWorkerSetupPackage::OnWorkerCompleted(): - SetupPackage setup failed due to unknown error" ? Attachment 0502_Log.txt (110 Downloads)
	Last edited by: Moderator_Lan at: 05/02/2025 16:21:40 Image embedded / Log attached
Suggestion To thank Quote Answer

5/2/2025 7:40 PM	Rate (0)
JimHalpert Joined: 7/11/2024 Last visit: 9/9/2025 Posts: 200 Rating: (27)	Helo plcspace I would check the following: - Run the installation with admin rights - Disable any firewall/ antivirus installed on the computer while the software is installed - Make sure that your system meets all the installation requirements described in the section "Important installation files" of the download page: SIMATIC STEP 7 incl. Safety, S7-PLCSIM and WinCC V20 TRIAL Download If none of this works, you should provide Siemens the full log so they can help you: Create a Support Request Good luck!!
	If this post has been useful, don't forget to rate it!😊
Suggestion To thank Quote Answer